The HyGEARS Graphic User Interface simplifies the design and evaluation of a gear set.
Every aspect of the topography and performance of a gear set can be assessed easily
Geometries can easily be created and imported in different ways.
Geometry and manufacturing Summaries may be consulted and edited on the fly,
using the Summary Editor. HyGEARS offer several editors to control every aspect of the geometry,
manufacturing and operation.
The most fundamental HyGEARS functions deal with kinematics.
Tooth Contact Analysis (TCA): the shape and location of the Bearing Pattern, Ease Off and
Transmission Error can be viewed and evaluated in one easy to assess display.
Loaded Tooth Contact Analysis (LTCA): Contact Stresses, Bearing Pattern under load,
Transmission Error, Bending Stresses and expected mesh efficiency are calculated and
displayed on the fly for quick assessment of the behavior under load.
Functions to measure and assess the quality of manufactured parts in relation to their design,
calculate Corrective Machine Settings (Closed Loop) or Reverse Engineer an unknown gear set
significantly expand the capabilities of gear designers and manufacturers.
HyGEARS creates and display grids of the Bearing Pattern or Transmission Error graph,
with or without load, as E, P, G, alignment, shaft angle, or run-out are combined in pairs
to produce a map-like envelope of the expected behavior of the gear set.
|Run Multiple Cases||
RMC allows to run up to 20 combinations of Torque, E, P, G, Shaft angle and
Alignment angle, and display selected results either graphically and in text mode
HyGEARS V 4.0